You can also use a large pair of metal snips. Make slow cuts to ensure a nice clean cut. recommends the use of fine tooth blade installed backwards on the saw when cutting the DuraShell® lattice. Safety first: always wear eye and ear protection when using power tools. With a wooden lattice not only are splinter ratings related to cutting the lattice but can also have to do with the charter of the lattice as it ages. With a vinyl lattice, the splinter rating comes into effect when cutting the lattice. Consider this, to get the results of the burning brand for boards a piece of lit wood lattice is put over the board to see how long it takes the board to catch fire. You will be hard pressed to find what, if any, fire rating tests a wood lattice has had done and passed. DuraShell® lattice has also passed the following test: ASTM D635-91 – Rate of Burning and/or Extent and Time of Burning test, ASTM D1929-91a – Ignition Properties, and ASTM D2843 – Smoke Density test. The DuraShell® lattice passed the Surface Burning ASTM E84-95 with the highest possible rating. The DuraShell® vinyl lattice has passed several fire tests and ratings. If either of these places were to catch fire, would the lattice contribute to the destruction? Vinyl: Some lattice projects are connected to directly your home or outdoor structure. Several things to consider when looking at the safety of lattice products are as follows. Of course safety is a concern during the installation of the lattice but also consider where the lattice will be installed and that it is a safe choice for that area. One consideration that often gets overlooked is the safety each lattice type provides. You will probably consider things like longevity, maintenance, and ease of installation to decide what lattice option is best for you. There are many things to take into consideration when choosing between vinyl and wood lattice products. When looking for lattice, the two most common options are vinyl and wood. What can you use? Lattice! Lattice has become one of the most used items for enhancing landscaped areas, creating privacy and hiding unsightly things such as air conditioners and trash cans. You have a lovely area that needs a finishing touch. So far, the plastic panels have been used mostly by contractors and home builders.The Safety of Vinyl Lattice vs. Many home centers and lumberyards stock lattice panels of pressure-treated wood, but plastic panels are more difficult to find at retail outlets because they are relatively new. Wax the bolt ends and wingnuts to retard rust. Drill 3/8-inch holes at the bolt locations, slip the panel over the bolt ends, and hold the panel in place with a washer and wingnut on each bolt. After the glue dries thoroughly, hold the panel in place against the protruding ends of the bolts and tap with a mallet to make impressions of the bolt ends on the panel frame. Cut the heads off several bolts and use an epoxy to glue the cut ends into holes drilled in the deck or porch framing at points where the panel is to be attached. The bolts should be five-sixteenths-inch thick and about 1 1/2 inches longer than the thickness of the panel frame. One way to attach a lattice panel so it is easily removed for access to a space is to use bolts and wingnuts.

Wooden lattice strips